|
|
|
IVT600 TriPorter |
| |
 |
| |
|
The IVT600 is all-in-one, low-cost, triple-play
testing solution. The first network installation tester that provides a
full range of physical wiring tests for the fast, efficient
delivery of IP-based voice, data and video services in the home
or small office with one integrated tool. The IVT600
refers to three services, voice,
data and video, that customers require today for 21st century
living. These three services travel over the premise cabling,
which needs to be tested and qualified to assure good quality
signals with adequate capacity.
This instrument measure the voltage by PoE, for example by VoIP
telephones. The IVT600
is our answer to this need, with its multi-functional,
broad-based capabilities. It is the natural evolution of our
core strengths, Test, Talk and Trace, in one all-encompassing
product. The IVT600 will
make your job of testing and configuring cables easier, faster
and more accurate, at a cost that is a fraction of what you
would expect to pay. |
| |
|
Features |
| |
|
l |
|
|
l |
Voice Telephony Testing
- Testing and verifying proper operation of each telephone
outlet assures adequate signal levels for all offered services. Power-up telephone
systems with the on-board dial tone simulator (SLIC) to test connected runs.
■ Advanced-function telephone butt set
■ Call analysis and discovery
■ Voltage and current readings
■ Line number discovery with captured digits
■ DTMFdecode to watch dialed call numbers for accuracy
■ Call Waiting service testing
■
SLIC
simulator to test lines without
outside provider service
■ Speakerphone for hands-free listening to dial tone and line monitoring
■ DSL
safe
■ 20-pc remote wiremapping
set |
|
l |
Data Testing Ethernet Networks
- Test newly-installed network cables on unpowered
systems or check active working networks to detect any physical
layer or configuration problems.
■ Configure the network, test the cables and guarantee the quality
■ Tests to
TIA568 interconnect specifications and connected length;
CAT5, 5E
and 6
■ Port discovery—ISDN, POTS, Token Ring, Ethernet, etc.
■ Negotiates at 100 Mbit with DHCP or manual addressing.
■ Ping for IP address information and configuration
■ Identify equipment on the other end of the line, showing its speed and type
■ Link speed displayed, 10/100Mbit
■ Hub blink to find connected ends in wiring closets
■ Qualify lines for VoIP service at 100Mbit speeds
■ Cisco Discovery Protocol ready
■ 20-pc remote wiremapping set |
|
l |
Video RF Detection and Testing
- HDTV, video-on-demand, cable modems, etc., all demand superb signal quality to work correctly. Testing for physical and electronic variations will guarantee that everything works as it should.
■ Detects and measures RF service energy levels
B/Mv
■ Tests for opens and shorts
■ Displays length of each tested run
■ 20-pc remote wiremapping set
■ The unique tone signal-which travels through splitter, filters and traps to trace lines while the system is powered-up and in-use is detectable by the Tri-Porter tracer unit |
|
|
|
IVT600 Tri-Porter Package Contents: |
|
1 |
IVT600 Main unit |
|
1 |
TU0051C-1
Remote tester/tracer IVT600 |
|
1 |
TP311
Set of 20 Coax remote
identifiers for Resi Testertm |
|
1 |
TP312 Set of 20 RJ45 Wiremappers for Resi Testertm |
|
1 |
TP314 Set of 20 RJ12 Wiremappers for Resi Testertm |
|
1 |
F-jack to F-jack Coax coupler |
|
1 |
TP63 Adapter F jack to BNC jack |
|
1 |
TT35 Paddle style tip for Tone Tracer |
|
1 |
LB40B Mini Headset / Microphone |
|
2 |
TP20 7.5in. Cable Assembly with Two No-Fault RJ12 Connectors |
|
2 |
TP55 12” Cable Ass shielded, RJ45 |
|
2 |
TP74 Cable for extending modular plug |
|
1 |
TG32 3.05 M(10 ft) safety ground cable |
|
1 |
LB35 Deluxe Cord Set, Bed of Nails |
|
1 |
ABA8 30,48 cm(1 ft) coax cable |
|
|
Specifications |
|
|
Combination of: |
Voice
Telephony Testing |
|
Data Testing Ethernet Networks |
|
Video RF Detection and Testing |
|
Network Testing: |
10Mb or 100Mb Ethernet |
|
Cable Types: |
Shielded or unshielded twisted pair CAT-3, CAT-5, CAT-5E
or CAT-6; coax; 2-, 4- and 6-pair telephone cabling |
|
Minimum Cable Length: |
Split pairs testing - 1 m.
Single-ended cable test - 1.25 m. |
|
Length Measurement Range: |
CAT-5/6 - 1 to 457 m.
Coax cable - 1 to 300 |
|
Physical Dimensions:
|
Main Unit Size:
20 x 8.9 x 5.6 cm.
Weight with Battery: 740 grams |
|
Tracer/Remote
Size: 15 x 5.8 x 4.3
cm.
Weight with Battery:
285 grams |
|
Temperature: |
Use:
0 to 50˚C (32 to 122˚F)
Storage: -30 to 80˚C
(-20 to 176˚F) |
| Relative
humidity: |
10% to 90%, non-condensing |
|
Battery life: |
|
Main Unit: |
6pcs. AA alkaline batteries - 2.5 years (standby) |
|
- No backlight: |
Cable Testing - 50 hrs. |
| |
Network Testing - 13 hrs. |
| |
Phone - 27 hrs. |
|
- 50% backlight: |
Cable Testing - 27 hrs. |
| |
Network Testing - 12 hrs. |
| |
Phone - 22 hrs. |
|
Tracer/Remote: |
1 pc.
9v Alkaline battery - 2.5 yrs. (standby) |
| |
Tracing - 13.5 hrs. |
|
|
Phone: 18 hrs. |
|
|
|
| |
TALK mode
with CWCID off 60 min. |
| |
TALK
mode with CWCID on 30 min.
|
|
Telephone Test Set Specifications |
|
Interfaces |
|
|
Telephone
system: |
Modular
telco |
|
Headset: |
2.5 mm
cell-phone type |
|
Ringer Equivalence |
|
|
In BELL
mode: |
0.0(no
ringer load) |
|
Tone Dialing
– DTMF output (into 600 Ohms): |
|
|
Tone-frequency error: |
± 1.5% |
|
Tone level |
|
|
- High
group: |
6 ± 2 dBm; |
|
- Low
group: |
-8 ± 2 dBm; |
|
- High vs
low difference: |
2 ± 1 dBm |
|
Flash
Duration: |
600 ± 50
ms |
|
Pause
Duration: |
Tone:3 s;
Pulse:3.4s |
|
Return
loss: |
14 dB at
600 Ohms |
|
Line-Current Range: |
15 to 120
mA |
|
Apparent
Line Resistance: |
275Ω at 20
mA |
|
Monitor
Mode Impedance: |
>230K Ω |
|
Measurement |
|
|
Voltage: |
0 to 128V
DC ± 5% |
|
Current: |
10 to 140
mA ± 5% |
| Qualified: |
CE, RoHS and
WEEE |
|
|
|
|
